The TURBOsplash PAC® evaporative panel is an injection molded, Polypropylene, 30 cm by 60 cm, U Channel frame made with four sections and a total of 38 blades molded perpendicularly to this framework. The blades are positioned as leaves are attached to the branch of a tree, and are used as surface area to be wet with a water film, as a series of steps over which water is splashed falling from one blade to the next, and as air conduits directing a reciprocating or spiralling air flow that helps to further break the water droplets and create a mist or fog condition that transfers a maximum of heat from the surface of the water to the air. It is modular.
Mechanical attachment points are provided on the long (60 cm) sides of the panel in the form of a male/female snap-together system which faces both inside and outside in order to connect two panels together face to face and then connect these double units together back to back. On each short (30 cm) side of the panel there is a molded pin and a tear-off perforated strap, (not shown in figure).